Heads DownThe golf club insert
for your backpack
Join the waitlist

Golf by bike

A full golf bag was not made for a bike.

Cycling with one is awkward. When you have an hour before or after work, getting to the range has to be easy.

The answer

Heads Down

Turn your backpack into a golf bag.

Heads Down is an insert for your clubs. Drop it in your backpack and ride.

Prototype. Join the waitlist to be first.

01 / 11   Modules

Three modules. Take what you need.

Woods, irons and wedges each get their own. Carry one, two or all three, with ten balls on board.

02 / 11   Lock

They slide together and stay together.

Slide one onto the next and they hold as one. No clips, no tools.

03 / 11   Ride

Heads down to ride.

Club heads sit low in the pack. One strap ties the shafts into a single bundle.

04 / 11   Apart

Irons never touch your woods.

Woods, irons and wedges each ride in their own bay.

05 / 11   Fit

It fits a 30 litre roll-top.

All three modules fit a 30 litre roll-top that is about 33 cm wide. Check the sizes against your pack.

06 / 11   Smaller pack

Smaller pack? Take two modules.

Leave the woods at home. Irons and wedges join up for a narrower pack: ten clubs, ten balls.

07 / 11   Smaller pack

Slim pack? Turn them sideways.

The same two modules join end to end to fit a slim pack.

This layout is still in development.

08 / 11   Smaller pack

Or take just one.

Six irons and a putter for a quick range session, with room left for the rest of your kit.

09 / 11   At the range

At the range, pull out the rack.

A slim rack rides in the insert. Pull it out and hook it on the table edge.

The rack and hook are a concept, still in development.

10 / 11   At the range

Hang it. Lay the clubs in.

Every club sits in its own hook, heads up and within reach. Lift one out and swing.

11 / 11   At the course

At the course, flip to play.

Turn the clubs heads up. Every grip has its own channel, and ten balls are ready in the tubes.

The full set

Fourteen clubs. Ten balls. One backpack.

A full set for the course, or just what you need for the range.

Stills

See inside.

Cut-through of the backpack with clubs heads down. Iron heads sit in the left bay, with the yellow rack rod standing in a grip channel beside them. The driver and woods are in the middle bay. Wedge heads sit in the right bay, beside a tube holding five golf balls.
Heads down. The range rack in a grip channel, balls in their tube.
Cut-through of the backpack with clubs heads up. Each grip stands in its own channel in the insert wall, and five golf balls sit in their tube on the right.
Heads up. Every grip in its own channel, balls beside the wedges.
The three modules joined together, seen from above. They are black with a yellow band at the base and at the top. The yellow rack rod is lifted part way out of its grip channel by its cord. Two ball tubes stand on the outside of the wedge module, with one ball sitting above them.
The three modules, joined. Ball tubes on the wedge module, rack rod with the irons.

Specification

The numbers.

These are the sizes of the current prototype. They may change before it goes on sale.

FitsAll three modules: a 30 L roll-top backpack, about 330 × 170 × 490 mm outside
Smaller packsIrons and wedges join side by side (188 × 150 × 250 mm) for a narrow pack. Or they turn sideways and join end to end (291 × 98 × 250 mm) for a pack of about 15 L that is at least 30 cm wide and 11 cm deep. The end-to-end layout is not printed or tested yet.
Insert size321 × 150 × 250 mm with all three modules joined
Capacity14 clubs: driver, 3 woods or hybrids, 6 irons, 3 wedges, putter. 10 golf balls.
ModulesWoods 130 mm wide (4 clubs), irons 95 mm (6 clubs), wedges 65 mm (4 clubs) plus 25 mm of ball tubes
Golf ballsTwo tubes on the wedge module, five balls each. A finger slot in each tube faces the bay, so you push a ball up from inside the insert.
Range rack28 mm rod with 10 hooks. Rides in a grip channel and hangs from a fold-out table hook. Clubs rest heads up with their grips on the floor; a wood needs the hook below it left empty. Concept, not built or tested yet. For a round the rack stays at home, so every club gets a channel.
Driver bay127 × 116 mm, sized for a 120 × 110 mm head
JointFull-height dovetail rails. The three modules join side by side. Irons and wedges also join end to end.
ColourBlack, with a yellow base and a yellow top
WeightAbout 950 g as a printed prototype, with 1.2 mm walls
StatusPrototype. Not on sale yet.

Accessories

Add-ons.

A yellow rack rod hanging from a table edge by a small blue hook. Nine golf clubs lie in its hooks with their heads up and their grips on the floor.

Concept

Table hook and rack

A fold-out hook sits on the table edge and a rack hangs from it. The clubs lie in its hooks, heads up and in view.

See it in the walkthrough

Planned

Grip strap

Ties the grips into one bundle for the ride.

Planned

Rain cover

Keeps the grips dry on a wet ride.

Waitlist

Be first to carry one.

We'll only email you about Heads Down. To be removed, email hello@baxarlabs.com.