Heads Down Table HookAccessory concept See the insert

Accessory concept

The Table Hook

Hang the bag. Keep the clubs up.

A fold-out hook that sits on a table edge and holds your loaded backpack by its top loop. The clubs stay upright and off the floor.

Concept. Not built or tested yet.

01 / 05   Pocket

Folds to a puck.

Both arms fold into the base. It is 90 mm across and 18 mm thick, small enough for a jacket pocket.

02 / 05   Unfold

Two hinges. One hook.

The long arm swings down. The short arm swings in and tips up, so the loop cannot slide off.

03 / 05   Table

Sits on any table edge.

A rubber pad grips the top. The hook reaches back under the base, so the weight pulls straight down through the pad.

  • Tabletopup to 45 mm thick
  • Target load10 kg

04 / 05   Hang

Hang the bag by its loop.

Lift the pack, pass the top loop over the hook and let go. Only the loop goes under the table.

05 / 05   Flip

Flip the clubs.

Take the strap off and turn the clubs over, the same as at the course. Heads up, every club is in view.

The result

Clubs up. Floor clear.

At a 75 cm table the pack hangs about 8 cm off the floor. It leans about 15 degrees, so the clubs stand clear of the edge.

Lean, clearance and heads-up balance are estimates until a prototype is tested.

Specification

The numbers.

These are design targets for a concept. Nothing here has been built or load tested.

Folded90 mm across, 18 mm thick
FitsTabletops up to 45 mm thick
Target load10 kg. A full set, the insert and the pack come to about 8 kg.
MaterialsMetal base and arms, rubber grip pad
Floor clearanceAbout 8 cm at a 75 cm table
StatusConcept. Not built or tested yet.

Accessories

The accessory set.

Three add-ons for the Heads Down insert.